. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 39 8. Inser t lock pin ( 2) in the h ole of t he t eeth (1) and hit it until it s top s the same le vel as the surfac e of teet h (1). 9. After replacing a bucket t ooth, always c heck th e following 1) A fter the l ock pin (2 ) has been k nocked in completely, heck that it is secur ed by the teeth (1) and surface. 2) L ightly hit l ock pin (2) in the reverse directio n from which it as hit in. 3) L ightly hit t he tip of th e teeth (1) from above and below, and it its side s from righ t and l eft.
4) C onfirm th at rubber p in loc k (3 ) and lock pi n (2) are s et as hown in t The life o f the teet h (1) can b e lengthened a nd the f requency of its replacement ca n be redu ced by turning it upside down so that it will wear eve Replace the rubbe r pin lock ( 3) and locking pin (2) a t the same time as replacing th e teeth (1) . This makes i t possible to preve nt the teet h (1) from falling out