Komatsu — REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) WARNING 4 - 40 It is dangerous if the work equipment moves by mistake w hen the teeth are being replaced. Set the work equipm ent in a stable condition , then stop th e engine and set the lock lever sec urely to the LOCK position. The pins can be knoc ked out only with strong force, so the re is a hazard that the pin may fly o area. ut. Check that there is no one in the surrounding There is a hazard that fragments will fly durin g the replacem ent work, so always wear protecti ve equipment like safety glasses and gloves. Replace the bucket t eeth before the adapt er starts to wear. put a block t the work 1. 1.

In order to enabl under the buck e tooth pin (1) to be pulled out, et bottom and mak e sure tha equipment rests o n it securely. Then m ove the lock lever to the LOCK position. In that case ensure th at the bucke t is level on the block. 2. Place a bar on th e head of pin (1), hit th e bar with a hammer to knock out the pin , then remove tooth ( REMARK f a diameter smaller than the pin. moved in this way, to ensure safety, please Use a round bar o f a diameter smaller t han the pin. I f it cannot be re moved in this way, to ensure saf contact your Kom atsu distributor and a sk them to c arry out the replacement work . 3. Clean the mount ing face.

Fit a new t ooth (2) in t he adapter, push in pin (1) pa rtially by hand, then l ock it with a hammer to install the tooth to the bucket.