. MAINTENANCE MAINTENANCE PROCEDURE low not inside the cover on the right side of machine. 4 - 49 4. Bleeding a ir from cyli NOTICE If the engine is r un at high sp eed immediately afte r startup or a cylinde r is pushe d up to its stroke end, air t aken inside the cylinder may cause dam age to the pi 1) Run th e engine at a mid-range spee d (1650 rpm ) and e xtend a nd retract the cylinders 4 to 5 times to a point 100 m m (3.9 in) fr om the end of the stroke. (B e caref ul not to operate to the end of t 2) Next, o perate eac h cylinder 3 to 4 t imes to the end of its strok 3) Finally , operate e ach cylinder 4 to 5 times to th e end of its stro ke to completely remo 5.
Bleeding a ir from swi ng moto (only after draining oil from swing moto NOTICE If the air is not b led from the swing motor, the m otor bearing s may b e damage 1) Loose n hose (3) while keeping the engine running at 2) idling. Tighten it a gain once oil sta rts to flow out. attemp Run th t to make a e engine at swing movemen low idling, and m t at that tim ake a swing slowly to the right and left more tha n twice eac 6. Bleeding a Bleed a ir from swi ir through a ng PPC circuit ir bleeder (4) inst