. MAINTENANCE MAINTENANCE PROCEDURE 4 - 50 7. Bleedin g air from t only w hen oil insi de travel motor case has been drai 1) Run the engin e at low idling, r emove hose (5) fro m port D, when the oil has flowed o ut, tighten it again. 2) Run the engin e at low idle and swing the work eq uipment 90° to bring it t o the side of th e track. track is raised slightly from 3) Jac k up the m achine until the the Rep ground. Ro tate the track u nder no loa d for 2 minutes. eat this pr ocedure on both the left and right s ides. 8.
Bleedin g air from attachment (whe n installed) NOTICE If the attachm ent maker s pecifies an air ble eding procedure for t he attachment itse lf, follow the specified pr ocedure to ble ed the air. f a brea ker or othe r attachment ha s been installed, ru n the engine at lo w idle a nd o perate th e attachment peda epeate dly (appro x. 10 times) unti l the air has been b led from the attachment circuit. NOTICE After com pleting the a ir bleeding operat ion, stop the engine, and leave the machine for 5 minute s before starting operations. This will r emove the a ir bubbles in the o il inside the hydraulic cylinders. Check tha t there is no leakage of oil an d wipe off any oil that has been