COMPONENT OPERATION / Swing Device SWING PARKING BRAKE The swing parking brake is a wet type multi-plate disc brake and a negative mechanism that releases the brake when brake release pressure acts on the brake piston chamber. The brake release pressure is supplied from the pilot pump only when either swing or front attachment is operated. In other cases (including engine stopping), the brake release pressure returns to the hydraulic oil tank, so that the brake is applied automatically by the spring. When Brake is Released 1. The swing or front attachment control lever is op- erated, the swing parking brake release spool in signal control valve is shifted.
Then, pilot pressure from the pilot pump is applied to port SH. 2. Pilot pressure to port SH pushes to open check valve (4) and acts on brake piston chamber (5). 3. As a result, as brake piston (2) is pushed upward, plate (7) and friction plate (6) are freed and the brake is released. When Brake is Applied 1. When the swing or front attachment control lever is returned to neutral, the swing parking brake release spool in signal control valve is returned to neutral and pilot pressure to port SH disappears. 2. Check valve (4) is closed and the brake release pressure through orifice (3) is released to the swing motor housing. 3.
As a result, the force of spring (1) acts on friction plate (6), which is engaged with the external cir- cumference of rotor (8), and on plate (7), which is engaged with the inside of motor housing through brake piston (2). Thus, the external circumfer- ence of rotor (8) is secured with friction force. When the engine stops, the brake is applied automatically as pressure is not applied to port SH. T3-2-4