COMPONENT OPERATION / Swing Device ZX180-3 class Low Pressure Relief Operation (Shockless Func- tion): 1. Pressure at port HP (swing circuit) is routed to oil chamber through the poppet orifice. 2. When pressure in the oil chamber is increased more than the force of spring 2, the piston moves to the left. 3. As long as the piston keeps moving, a pressure difference is developed between the front and the rear of poppet. When this pressure difference is increased more than spring force, the poppet is unseated and pressure oil flows to port LP. 4. When the piston is moved to full stroke, the pres- sure difference between the front and the rear of poppet disappears and the poppet is seated.
High Pressure Relief Operation (Overload Preven- tion): 1. After the piston is moved to full stroke, the circuit pressure becomes the relief set-pressure. 2. If pressure at port HP increases more than the spring 1 set-pressure, the poppet is unseated pressure oil flows to port LP. 3. When pressure at port HP is reduced to the specified level, the poppet is seated by the spring 1 force. Spring 1 Piston Spring 2 Oil Chamber Orifice Return Circuit (Port LP) HP Plungert Poppet T107-02-04-020 NOTE: Although the structure of relief valve is dif- ferent, the operational principle is same. T3-2-9