Isuzu — 4-43 In case of emergency

(7) Depress the clutch pedal fully and turn the key switch to "START" position to start the engine at the same time the glow plug indicator light goes off. If the engine does not start, repeat the steps (4), (5), (6) and (7). (8) Immediately after rev-up, put your hand off key and your foot off accelerator pedal. (9) Allow the engine to idle for 5 min. With air in fuel system, smooth flow of fuel into the engine is interrupted and to prevent this bleeding of the fuel system should be performed. (1) Operate hand pump until it becomes hard to push (about 15 pushes). (3) Operate hand pump until it becomes hard to push (about 10 pushes).

(5) Operate hand pump until it becomes hard to push (about 5 pushes). (6) When the key switch is turned to "ON" position, the glow plug indicator light comes on and goes off after approx. 4.0 to 7.0 seconds (with cold engine). Please notice the glow plug indicator light does not turn on when the engine already warm (coolant temperature above 25 ° C). - 4–48 - (2) Wait for 1 min. (4) Wait for 1 min. If the fuel tank has gone empty, there is a chance that air has been allowed into the fuel system. With air in the fuel system, smooth flow of fuel into the engine is interrupted. To prevent this, bleeding of the fuel system should be performed.

If the fuel tank has been emptied, the chance is that air might have been allowed into the fuel system. BLEEDING OF FUEL SYSTEM Bleeding of the fuel system CAUTION DRIVING