Isuzu — 4-43 In case of emergency

DRIVING 1. Loosen the plug and operate the priming pump more than 20 times until the fuel near the plug overflows. 2. Tighten the plug and operate the priming pump more than 10 times until it is filled with fuel. After waiting for a minute, loosen the plug and bleed out 3. fuel to the engine. Priming pump Air bleed plug 4HK1-TC 1. Loosen the priming pump cap and pump the fuel into the injection pump by manually operating the pump. 2. With a screwdriver or a wrench, loosen the bleeder screw on the injection pump and continue to pump the priming pump until air bubbles disappear from the fuel pumped out through the bleeder screw. 3.

Securely tighten the bleeder screw when air bubbles disappear and the fuel comes out in a solid stream. 4H (Except 4HF1-2 4HG1-T 4HK1-TC ) Priming pump - 4–49 - 1. Operate the priming pump on the water separator to bleed the fuel system air into the injection pump. 2. When you have finished the bleeding, start the engine with the ignition key switch. 3. If the engine does not start within ten seconds, repeat the bleeding operation. 4J 4HF1-2 4HG1-T