4. After draining, securely tighten the drain plug by turning it clockwise and push the priming pump up and down several times. 5. After starting the engine, check to see that there are no fuel leaks from the drain plug. Also check that the water separator indicator has turned off. If the water separator requires frequent draining, have the fuel tank drained at your nearest Isuzu dealer. CAUTION When the water separator indicator light comes on, water should be drained immediately in the following manner: 1. Find a safe place to park the vehicle. 2. Open the engine inspection cover and place a container (approximately 0.2 liters capacity) beneath the drain plug on the separator. 3.
Loosen the drain plug by turning it counterclockwise and push the priming pump down about ten times until the water is drained. Draining of the water separator 4J - 4–50 - 4HF1-2 4HG1-T 4. Start the engine without depressing the accelerator pedal. After starting, maintain the idling rotation for 5 seconds. 5. Slowly rotate the idling control knob fully clockwise and maintain it for 3 minutes. 6. Fully depress the accelerator pedal and increase the rotations to maximum. Repeat this operation several times. 7. Rotate the idling control knob counterclockwise and return to idling rotation. DRIVING 4HF1-2 4HG1-T