DRIVING If the water separator requires frequent draining, have the fuel tank drained at your nearest Isuzu dealer. It would be better not to use the water separator, since it may possibly exert a bad effect on the fuel system. Priming pump CAUTION 3. Loosen the air bleeding plug and drain plug by turning it counterclockwise, then drain water. 4. After draining, securely tighten the drain plug and air bleeding plug by turning it clockwise. 5. Operate the priming pump on the injection pump to bleed the fuel system. 6. 4HF1 and 4HG1 models: After starting the engine, check to see that no fuel leaks from the drain plug. Also check that the water separator indicator has turned off.
4HE1-TC model: After starting the engine, check to see that no fuel leaks from the drain plug. - 4–51 - 4HF1 and 4HG1 models: When the water separator indicator light comes on water should be drained immediately. 4HE1-TC model: When the condensed water in the pre-fuel filter (water separator) comes to the warning level indicated on its plastic body, drain the fluid immediately. 1. Find a safe place to park the vehicle. 2. Place a container (Approximately 0.2 liters capacity) beneath the drain plug on the separator. Draining of the water separator 4HF1 and 4HG1 models