SERVICE AND MAINTENANCE 5. After filling the system to the full, pull out the filling hose and check to see if air trapped in the system is dislodged and the coolant level goes down. Should the coolant level go down, repeat topping-up until there is no more drop in the coolant level. 6. After directly filling the radiator, fill the reservoir to the maximum level. 7. Install and tighten radiator cap and start the engine. After idling for 2 to 3 minutes, stop the engine and reopen radiator cap. If the water level is lower, replenish. 3. To refill engine coolant, pour coolant up to filler neck using a filling hose which is smaller in outside diameter of the filler neck.
Otherwise air between the filler neck and the filling hose will block entry, preventing the system from completely filling up. 4. Keep a filling rate of 9 liters/min. or less. Filling over this maximum rate may force air inside the engine and radiator. And also, the coolant overflow will increase, making it difficult to determine whether or not the system is completely full. - 7–31 - A failure to correctly fill the engine cooling system in changing or topping up coolant may sometimes cause the coolant to overflow from the filler neck even before the engine and radiator are completely full.
If the engine runs under this condition, the shortage of coolant may possibly result in engine overheating. To avoid such trouble, the following precautions should be taken in filling the system. CAUTION