The parking brake lever stroke is normal when the lever comes within 6 to 8 notches when pulled with a force of 15 kg (33 lb, 147N) . The parking brake can be adjusted in the following manner: 1. Chock the front wheels and release the parking brake. Parking brake adjustment Air bleeding from the brake fluid line (in the master cylinder, wheel cylinder etc.) may be performed only after air is bled from the hydro booster and with the engine running. Air cannot be bled from the brake fluid line if the engine is not running. When bleeding air from both the hydro booster and the brake fluid line, always bleed air from the hydro booster first per steps (1) through (9) above.
CAUTION - 7–40 - SERVICE AND MAINTENANCE 9. Repeat steps (6) to (8) the necessary number of times until the fluid level is stabilized and no air bubbles are found in the fluid. If bubbles are found, wait until they disappear before resuming work. 10. Air bleeding from the brake fluid line (in the master cylinder, wheel cylinder, etc.) may be performed at this stage with the engine running as instructed below. 11. Depress the brake pedal slowly but firmly about 30 times (at the interval of 1 to 3 seconds) to the booster full-load range while the engine is running. Do not keep the pedal depressed at the full-load position longer than 1 second. 12.
Stop the engine and depress the brake pedal repeatedly at least 10 times. 13. Check the condition of the working fluid in the reservoir tank. Air bleeding is completed double if the fluid level is stabilized and no air bubbles are found. If bubbles are found, wait until they disappear and repeat steps (11) and (12).