SERVICE AND MAINTENANCE 1. Add working fluid in the hydro booster reservoir tank to a level between the MIN and MAX marks. 2. Run the engine for about 5 seconds. 3. Stop the engine and read the fluid level in the reservoir tank. 4. If the level is below the MIN mark, add more fluid to a level between the MIN and MAX marks. 5. Repeat steps (2) to (4) the necessary number of times until the fluid level is stabilized and no air bubbles are found in the fluid. If bubbles are found, wait until they disappear before resuming work. 6. With the engine running, depress the brake pedal slowly about 5 times. 7. Stop the engine and read the fluid level in the reservoir tank.
If the level is below the MIN mark, add more fluid to a level between the MIN and MAX marks. 8. With the engine turnred off, depress the brake pedal at least 10 times. The temperature inside piping or the assembly or piping from the vehicle, important, especially when removing The hydro booster working fluid activated with the engine running. hydro booster assembly can rise above 100°C during frequent brake operation. Use every caution when components.
When removing the hydro booster assembly from the vehicle, stop the engine and let it cool down for at least 30 minutes The hydro booster accumulator maintains high pressure long after disconnecting the hydro booster stop the engine and depress the brake pedal at least 10 times until the accumulator pressure drops to the atmospheric pressure. This is the replaceable accumulator and booster assembly. The working fluid will splash if the pressure is becomes hot when the pump is handling the hydro booster the engine is turned off. Before pressure switch from the hydro - 7–39 - before starting work. still high. Bleeding of the hydro booster working fluid The hydro booster is designed for ATFlll.
Use of other working fluids may affect rubber parts and lead to Remember that the brake fluid used from the hydro booster components, working fluid away from the master mistake, rubber parts will deteriorate due to poor lubrication. This may leakage or malfunction, or to vehicle fire or other serious accidents due use with working fluid BESCO in the master cylinder is entirely different in properties from the working fluid used in the hydro Use every caution to keep the master cylinder brake fluid away and, similarly, the hydro booster In the event the hydro booster cylinder brake fluid are mixed by cause brake troubles due to oil WARNING malfunction or oil leakage.
working fluid and the master cylinder components. to the dragging brake. booster. V