Drain the rear axle case by removing the drain plug (D) on the lower part of the rear axle case. Fill the rear axle case to the level plug (L) with specified gear oil through the level plug hole. If your vehicle is equipped with standard differential, use GL-5 Gear Lubricant of the correct viscosity for the existing ambient temperatures. If your vehicle is equipped with the optional limited slip differential (Rear AXLE), use GL-5 Limited Slip Differential Gear Lubricant together with Limited Slip Differential Lubricant Additive (Isuzu Part No. 8-01052-358-0, GM Part No.#1052358) or equivalent. Changing differential oil 4. Replace the O-ring and install the drain plug (D) of Smoother oil pan.
5. Pour the specified fluid from level gauge guide tube. Refer to "Smoother clutch fluid level". CAUTION Do not reuse old O-ring. - 7–68 - SERVICE AND MAINTENANCE 1. Park the vehicle on the level ground. 2. Remove the drain plug (D) and O-ring of Smoother oil pan. 3. Drain the fluid. When draining, check that the amount of fluid is adequate and there is no metal pieces or foreign substances. (D) Changing Smoother clutch fluid SA Hot fluid can cause severe skin burns. Allow the transmission to cool before draining the Smoother WARNING clutch fluid.