Isuzu — 7-65 Lubrication guide

SERVICE AND MAINTENANCE 10. Air bleeding from the brake fluid line (in the master cylinder, wheel cylinder, etc.) may be performed at this stage with the engine running as instructed below. 11. Depress the brake pedal slowly but firmly about 30 times (at the interval of 1 to 3 seconds) to the booster full-load range while the engine is running. Do not keep the pedal depressed at the full-load position longer than 1 second. 12. Stop the engine, and depress the brake pedal repeatedly at least 10 times. 13. Check the condition of the working fluid in the reservoir tank. Air bleeding is completed if the fluid level is stabilized and no air bubbles are found.

If bubbles are found, wait until they disappear and repeat steps (11) and (12). 1. Add working fluid in the hydro booster reservoir tank to a level between the MIN and MAX marks. 2. Run the engine for about 5 seconds. 3. Stop the engine and read the fluid level in the reservoir tank. 4. If the level is below the MIN mark, add more fluid to a level between the MIN and MAX marks. 5. Repeat steps (2) to (4) the necessary number of times until the fluid level is stabilized and no air bubbles are found in the fluid. If bubbles are found, wait until they disappear before resuming work. 6. With the engine running, depress the brake pedal slowly about 5 times. 7.

Stop the engine and read the fluid level in the reservoir tank. If the level is below the MIN mark, add more fluid to a level between the MIN and MAX marks. 8. With the engine turned off, depress the brake pedal at least 10 times. 9. Repeat steps (6) to (8) the necessary number of times until the fluid level is stabilized and no air bubbles are found in the fluid. If bubbles are found, wait until they disappear before resuming work. - 7–71 - activated with the engine running. brake operation. Use every caution components.

When removing the maintains high pressure long after depress the brake pedal at least 10 pressure drops to the atmospheric The hydro booster working fluid becomes hot when the pump is The temperature inside piping or the hydro booster assembly can rise above 100 ° C during frequent when handling the hydro booster hydro booster assembly from the vehicle, stop the engine and let it cool down for at least 30 minutes The hydro booster accumulator the engine is turned off. Before disconnecting the hydro booster especially when removing the replaceable accumulator and pressure switch from the hydro booster assembly.

The working fluid will splash if the pressure is assembly or piping from the vehicle, stop the engine and times until the accumulator pressure. This is important before starting work. still high.