2. CIRCUIT DIAGRAM BY SYSTEMS 37. BLINKCODE DESCRIPTION For blinkcode activation warning lamp respectively the ASR-L has to be grounded for a given time by a push button switch. Which signal lamp has to be used depends on ECU type respec- tively its parametersetting. The duration defines the mode. After release of the switch the signal light will be on for further 0.5 sec. to confirm that the grounding was detected and accepted by the Electronic Control Unit, ECU. If a fault occurs or signal lamp is grounded for longer than 6.3 sec. blinkcode will be terminated.
If grounding is detected for more than 15 sec., fault detection of warning lamp open circuit can be detected and stored in ECU EEPROM (non-volatile memory). Blinkcode activation on ASR- lamp do not cause fault memorizing because open circuit is not detected. Dashboard signal lamp check devices which grounds the lamp in the described way acti- vates the related mode. 1) DIAGNOSTIC MODE For diagnostic mode activation signal lamp has to be grounded for 0.5 sec. to 3.0 sec. FC : Faultcode // 1 to 8 // a: first part ; b: second part see Blinkcode List FC1 repeated because fault is actual If one fault was detected during current "IGNITION ON" (autual fault) the ECU blinks out that fault.
If more faults were detected during that period blinkcode shows just the latest detected fault. For termination ignition must be switched off/on or vehicle has to move (measured speed of more than one axle). If there is no actual fault, the last fault will be blinked out fist. Further fault numbers may not represent the sequence of occurrence. The stored fault blink mode is self terminating. FC : Faultcode // 1 to 8 // a: first part ; b:second part see Blinkcode List Blinkcode timing: 0.2s OFF 0.1s ON FAST 104 0.5s 0.5s OFF NORM