Daewoo Commercial Vehicle DE/DV Series — Daewoo Commercial Vehicle DV-0 — user manual

2. CIRCUIT DIAGRAM BY SYSTEMS 2) SYSTEM MODE, CLEAR ALL MEMORIZED FAULTS: System mode is activated if the signal lamp is grounded for a time of 3 to 6.3 sec. All stored faults are erased, if no fault is actual. For termination ignition has to be switched off / on or vehicle has to move (measured speed of more than one axle). System code (one number) represents the expected system and should be used to check correct ECU type. After activating system mode ASR(ATC) is disabled for dyno tests. With WL blinkcode ECU's ASR(ATC) lamp is permanently on indicating ASR(ATC) disabling. Two seconds after system mode activation further functions are available: 1.

ASR (ATC) engine control function can be tested by two times extra grounding of a time of >0.5 sec (ASR(ATC) commands idle torque for 10 sec.) 2. ASR(ATC) respectively Retardercontrol system can be reconfigured by three times extra grounding of a time of > 0.5 sec (missing components can be confirmed). Reconfiguration is confirmed by four short flashes Without actual fault : CLEARS ALL MEMORIZED FAULTS CLEAR ALL is accepted and confirmed by 8 short flashes followed by the system code. Without actual fault Identical to no actual fault condition but CLEAR ALL is not accepted. System : 105 2 x 4S/4M 6 x 4S/3M (VAR rear) 3 x 4S/3M (MAR/VAR front) 7 x 4S/2M (VAR both)