2. CIRCUIT DIAGRAM BY SYSTEMS 3) ENGINE CONTROL FUNCTION TEST: For testing engine control function a 10 sec idle torque can be commanded if the signal lamp is additionally two times grounded. The duration of grounding has to be longer than 0.5 sec. and time between the two grounding has to be less than 3 sec. The 10 sec. time starts 3 sec. after last grounding. Parallel to the engine control function test the system blinkout continues. 4) RECONFIGURATION: - The ECU modifies its default system (without ASR/ATC) to ASR/ATC if a differential brake valve and one of the engine control interfaces are connected.
- Connected SAE J1939 (SAE J 1922) without a differential brake valve cause an extension of the supervised ABS components. - Connected endurance brake relay (DBR output) or received retarder messages on data link (SAE J1922 resp. SAE J1939) stores and extends the ABS components too. Without reconfiguration such ECU'S could not be used in vehicles without those components. Additional to diagnostic tools this reconfiguration can be done by the means of blinkcode. To avoid unintentional reconfiguration this function has to be confirmed by three times grounding of the signal lamp in the way described above for engine control function test.
Before system code continues 4 short flashes confirm the modification of parameters. The ASR/ATC lamp bulbtest duration shows whether ASR/ATC is configured or not. Without ASR/ ATC:1,5 sec. ;with ASR/ATC 3 sec. (as Warning Lamp). 5) DYNOTESTER FUNCTION: For certain dynotester it is necessary to disable ASR/ATC to allow higher speed difference between driven and steering axle. By activating system mode ASR/ATC can be disabled. With WL Blinkcode ECU's ASR(ATC) lamp is permanently on indicating ASR(ATC) diabling. To prevent dangerous situations caused by brakeforce in case of ignition off/on or powersupply inter rupts, ASR/ATC is disabled as long as there are speed differences after ECU reset.
For indication the ASR/ATC lamp is permanently on until ignition is switched off/on. 106