UEN00664-00 50 Disassembly and assembly Work equipment q Except demolition spec. a Articles 5. & 6. for except the demolition spec. 5. Remove lock bolt (3). 6. Remove plate (4) and remove the head pin. [*3] a Check the number as well as locations of the shims used. Removal and installation of the work equipment assembly Special tools 7. Start the engine and then retract the piston rod. a Bind the piston rod with wire etc. and put it down the blocking tools so that the piston rod does not slip out or allot a support so that the cylinder doesn't fall down to the bottom side. If a support is allotted, remove the grease fitting at the bottom side.
a Remove the boom cylinder on the other side in the same manner. a If bumping of the lifting hook against the work equipment lamp is anticipated in lift- ing the work equipment, the lamp must be removed. 8. Disconnect 2 pcs. of bucket cylinder hose (6) & 2 pcs. of arm cylinder hose (7). a Apply the oil restraining plug and then fix the hoses to the valve side by use of ropes. 9. Disconnect intermediate connector for work- ing lamp A13 (8). Removal k Safely lower the work equipment to the ground by extending the arm and the bucket completely. Set the lock lever in the lock position, k Release the residual pressure in the hydraulic circuit.
Refer to the Release of Remaining Pressure in Hydraulic Circuit section in the Testing and adjusting chap- ter of this manual. 1. Disconnect grease hose (1). 2. Sling the boom cylinder Assembly (2). q Demolition spec. a Articles 3. & 4. for the demolition spec. 3. Remove the lock bolt and nut (3). [*1] 4. Remove plate (4), then remove head pin (5). [*2] a Check the number as well as locations of the shims used.
2 PC210, 230,240-8 Symbol Part number Part name Essentiality Quantity N/R Illustration V 796-900-1200 Remover t 1 • 796-900-1210 • Sleeve 1 • 792-900-1520 • Plate 1 • 799-900-1230 • Screw 1 • 796-900-1240 • Adapter 1 • 01643-33080 • Washer 1 • 01803-13034 • Nut 1 790-101-4000 Puller (490kN {50 ton} long) t 1 790-101-1102 Pump (294 kN {30 ton}) t 1