Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of operator cab glass (stuck glass)

UEN00665-00 50 Disassembly and assembly Special tools (The figure shows the operator's cab of a wheel loader.) Removal a Remove the window glass to be replaced according to the following procedure. 1. Using seal cutter [1], cut the adhesive between broken window glass (7) and operator's cab (metal sheet)(8). a If the window glass is broken finely, it may be removed with a knife [4] and a screw- driver. a Widening the cut with a flat blade screw- driver, cut the dam rubber and adhesive with knife [4].

(The figure shows the operator's cab of a wheel loader.) a If a seal cutter is not available, make holes on the adhesive and dam rubber with a drill and pass a fine wire (piano wire, etc.) [2] through the holes. Then, grip the both ends of the wire with priors [3], etc.(or hold them by winding them onto something) and move the wire to the right and left to cut the adhesive and dam rubber. Since the wire may be broken by the fric- tional heat, apply lubricant to the wire. 2. Remove the window glass. 6 PC210, 230, 240-8 Symbol Part number Part name Necessity Q’ty N/R Sketch X 2 793-498-1210 Lifter (Suction cup) t 2 3 20Y-54-13180 Stopper rubber t 2