Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of operator cab glass (stuck glass)

50 Disassembly and assembly UEN00665-00 Installation a Even if the primer is packed again just after it is unpacked, use it within 24 hours after it is unpacked for the first time. (Discard the primer 24 hours after it is unpacked.) 1) Stir the primers for both of paint and glass sufficiently before using them. a If the primer has been stored in a refrig- erator, leave it at the room temperature for at least half a day before stirring it. (If the primer is unpacked just after taken out of the refrigerator, water will be condensed. Accordingly, leave the primer at the room temperature for a sufficient time.) 2) When reusing primer brush (11), wash it in white gasoline.

a After washing the brush, check it again for dirt and foreign matter. a Prepare respective brushes for the paint primer and glass primer. 1. Using a knife and scraper [5], remove the remaining adhesive and dam rubber from the metal sheets (glass sticking surfaces) of the operator's cab. a Remove the adhesive and dam rubber to a degree that they will not affect adhesion of the new adhesive. Take care not to scratch the painted surfaces. (If the painted surfaces are scratched, adhesion will be lowered.) (The figure shows the operator's cab of a wheel loader.) 2. Remove oil, dust, and dirt, etc. form the stick- ing surfaces of cab (8) and window glass (9) with white gasoline.

a If the sticking surfaces are not cleaned well, the glass may not be stuck perfectly. a Clean the all black part on the back side of the window glass. a After cleaning the sticking surfaces, leave them for at lease 5 minutes to dry. (The figure shows the operator's cab of a wheel loader.) 3) Evenly apply the paint primer to the surfaces to stick dam rubber and its outside surfaces to apply adhesive on operator's cab (8). 2 Paint primer: Sunstar primer for painting plane 580 super a Do not apply the primer more than 2 times. (If it is applied more than 2 times, its performance will be lowered.) 3. Apply primer (10). a The using limit of primer is 4 months after the date of manufacture.

Do not use the primer after this limit. a Use the primer within 2 hours after un- packing it. PC210, 230, 240-8 7