50 Disassembly and assembly UEN00665-00 Installation a Install the right corner block so that clear- ance (a) between the rail and right corner block (2) becomes 0 – 2.0 mm. a Install the right corner block so that there is no level difference at the rolling surface (R) of the roller. q Carry out installation in the reverse order to removal. [*1] q Adjust opening and closing of the front window assembly according to the following proce- dure. 1. Open and close the front window to check that it does not interfere with the rails and that the rollers are not hitched. 2.
If there is any problem in opening and closing of the front window, loosen the mounting bolt of roller adjustment bracket (13) and adjust the condition of the front window, and then tighten the mounting bolt again. a Make sure that bracket (13) is not mounted on the angle. 3 Mounting bolt: 34.3 Nm {3.5 kgm} 5. Install left corner block (1). a Fully tighten the block after adjusting the “Close“ position in the following step 6. a Install the left corner block so that clear- ance (b) between the rail and left corner block (1) becomes 0 – 2.0 mm. a Install the right corner block so that there is no level difference at the rolling surface (R) of the roller. (Refer to the above fig- ure.) 3.
Raise the front window assembly and fix it with the rear locks (on both sides). a Check that the locks in the rear of the operator's cab are securely fastened. 4. Install right corner block (2). a Fully tighten the block after adjusting the “Close“ position in the following step 6. PC210, 230, 240-8 17