UEN00665-00 50 Disassembly and assembly 6. Adjust the “Close“ position of the front window assembly lock according to the following pro- cedure. 1) Tighten left and right corner blocks (1) and (2) at roughly right positions so that front window glass (14) is attached firmly to cab-side trim seal (19). 7. After the adjustment, splash water heavily over the front window glass and check that the water does not leak into the cab. 2) Check the working condition of right and left locks (16) and (17) when opening and closing the front window assembly. q If right and left locks (16) and (17) do not work normally.
1] Loosen lock fitting bolt (18), move lock (16) forward, and then tighten the bolt again. a The same applies to the right side. 2] After moving the lock, recheck the fit- ness of front window glass (14) and cab-side trim seal (15) which was checked in step 1). 3] Repeat the work in 1] and 2] until the fitness of the front window glass and the working condition of locks (16) and (17) are both acceptable, and then tighten the mounting bolts of the right and left corner blocks. 18 PC210, 230, 240-8