20 Standard value table UEN00227-00 PC210, 230, 240-8 13 Applicable model PC240LC, 240NLC-8 Cate- gory Item Measurement condition Unit Standard value for new machine Judgement criteria Swing Swing brake angle • Hydraulic oil temperature: Within operating range • Engine running at high idle • Working mode: P mode • Swing circle misalignment amount when stopping after one turn • For measuring posture, see Swing 1 deg. (mm) Max. 165 (—) Max. 200 (—) Time taken to start swing • Hydraulic oil temperature: Within operating range • Engine running at high idle • Working mode: P mode • Time required for passing points 90° and 180° from starting point • For measuring posture, see Swing 1 90° sec.
3.0 ± 0.3 Max. 3.5 180° sec. 4.5 ± 0.4 Max. 5.4 Time taken to swing • Hydraulic oil temperature: Within operating range • Engine running at high idle • Working mode: P mode • Time required for 5 more turns after making initial one turn • For measuring posture, see Swing 1 sec. 25.7 ± 2.8 Max. 31 Hydraulic drift of swing • Hydraulic oil temperature: Within operating range • Engine stopped • Keeping upper structure transverse on slope of 15° • Notching a mating mark on inner and outer races of swing circle • Mating mark misalignment amount during 5 minutes • For measuring posture, see Swing 2 mm 0 0 Leakage from swing motor • Hydraulic oil temperature:
Within operating range • Engine running at high idle • Swing lock switch: ON • Leakage amount for one minute during swing relief l/min Max. 5 Max. 10 Travel Travel speed (without load) • Hydraulic oil temperature: Within operating range • Engine running at high idle • Working mode: P mode • Time required for track shoes to make 5 turns after making one initial idle turn • For measuring posture, see Travel 1 Lo sec. 58.1(+6.5/–5.3) 52.8 – 68.6 Mi sec. 42.5(+4.7/–3.9) 38.6 – 51.2 Hi sec. 30.3(+1.6/–1.4) 28.9 – 33.9