UEN00228-00 30 Testing and adjusting Measuring engine speed 1 3. Measuring high idle speed 1) Start the engine and set the fuel control dial in the high idle (MAX) position. 2) Set the working mode in the power mode (P) and turn the auto-decelerator OFF. 3) Set all the levers and pedals for work equipment control, swing control, and travel in neutral and measure the engine speed. a Measure the engine speed with the monitoring function of the machine monitor. a Measure the engine speed under the following condition. q Engine coolant temperature: Within oper- ating range q Hydraulic oil temperature: Within operat- ing range 4.
Measuring 2-pump relief speed 1) Start the engine and operate the arm cyl- inder to the IN stroke end. 2) Set the fuel control dial in the high idle (MAX) position and set the working mode in the power mode (P). 3) Operate the left work equipment control lever to relieve the arm circuit at the IN stroke end and measure the engine speed. 1. Preparation work Operate the machine monitor so that the engine speed can be monitored. a For the operating method of the machine monitor, see Special functions of machine monitor. a Monitoring code: 01002 Engine speed 5.
Measuring 2-pump relief and power maxi- mizing speed (near rated speed) 1) Start the engine and operate the arm cyl- inder to the IN stroke end. 2) Set the fuel control dial in the high idle (MAX) position and set the working mode in the power mode (P). 3) While operating the left work equipment control lever to relieve the arm circuit at the IN stroke end and depressing the power maximizing switch, measure the engine speed. a The power maximizing function is reset automatically in about 8.5 seconds even if the switch is kept depressed. Accordingly, measure the engine speed in that period. 2.
Measuring low idle speed 1) Start the engine and set the fuel control dial in the low idle (MIN) position. 2) Set all the levers and pedals for work equipment control, swing control, and travel in neutral and measure the engine speed. 6. Measuring auto-deceleration speed 1) Start the engine, set the fuel control dial in the high idle position (MAX), and turn the auto-decelerator ON. 2) Set all the levers and pedals for work equipment control, swing control, and travel in neutral and measure the engine speed when the auto-decelerator oper- ates. a The engine speed lowers to a certain level about 5 seconds after all the levers and pedals are set in neutral.
This level is the auto-deceleration speed. 6 PC210, 230, 240-8