Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring intake air pressure (boost pressure)

30 Testing and adjusting UEN00228-00 Measuring intake air pressure (boost pressure) 1 3. Run the engine at middle or higher speed and bleed oil from the hose. a Insert the connecting parts of the gauge and hose about a half and open the self- seal on the hose side repeatedly, and the oil will be drained. a If Pm kit (A) is available, you use the air- bleeding coupling (790-261-1130) in that kit. a If oil is left in the hose, the gauge does not work. Accordingly, be sure to drain the oil. a Measuring tools for intake air pressure (boost pressure) k Stop the machine on a level ground and lower the work equipment to the ground. a Measure the intake air pressure under the fol- lowing condition.

q Engine coolant temperature: Within oper- ating range 4. Set the working mode in the power mode (P) and turn the swing lock switch ON. a If the swing lock switch is turned ON, the main relief valve is set for high-pressure relief. q Hydraulic oil temperature: Within operat- ing range 1. Open the engine hood and remove intake air pressure pickup plug (1) from the intake air connector. 5. While running the engine at high idle, relieve the arm circuit and measure the intake air pressure. 2. Install nipple [1] of boost gauge kit R and con- nect it to gauge [2]. 6. After finishing measurement, remove the mea- suring tools and return the removed parts. PC210, 230, 240-8 7 Symbol Part No.

Part name R 799-201-2202 Boost gauge kit