30 Testing and adjusting UEN00228-00 Adjusting valve clearance 1 4. Rotate the crankshaft forward with gear B1 and set wide slit (b) of the rotation sensor ring to projection top (a) of front cover. a Projection top (a) must be within the range of wide slit (b) when it is seen from the air conditioner compressor side. a If you can see the yellow marks of projec- tion top (a) and wide slit (b), you may set them to each other. a Measuring tools for valve clearance k Stop the machine on a level ground and lower the work equipment to the ground. a Measure the valve clearance under the follow- ing condition. k When the crankshaft is set as above, the piston in the No. 1 or No.
6 cylinder is not set to the compression top dead center (TDC). Take care. q Engine coolant temperature: Normal tem- perature 1. Open the engine hood and remove the belt guard from the top of the air conditioner com- pressor. 2. Remove cylinder head cover (1). a Since the breather connector on the rear side of the cylinder head cover is con- nected to the flywheel housing through the O-ring, pull it together with the cylinder head cover. 5. Check the movement of the rocker arm of the No. 1 cylinder to judge the valve to be adjusted.
a If you can move the rocker arms of air intake valves (IN) with the hand by the valve clearance, adjust the valves marked with Q in the valve arrangement drawing. a If you can move the rocker arms of exhaust valves (EX) with the hand by the valve clearance, adjust the valves marked with q in the valve arrangement drawing. a Valve arrangement drawing 3. Remove plug (2) from the top of the starting motor and insert gear B1 . PC210, 230, 240-8 9 Symbol Part No. Part name B 1 795-799-1131 Gear 2 Commercially available Thickness gauge