UEN00228-00 30 Testing and adjusting Measuring fuel pressure 1 a Measuring tools for fuel pressure k Stop the machine on a level ground and lower the work equipment to the ground. a Measure only the fuel pressure in the low-pres- sure circuit from the feed pump through the fuel main filter to the supply pump and the return circuit from the supply pump/common rail/injector to fuel tank. 3) Run the engine at low idle and measure the pressure in the fuel low-pressure cir- cuit. a If the pressure in the fuel low-pres- sure circuit is in the following range, it is normal.
k Since the pressure in the high-pressure cir- cuit from the supply pump through the common rail to the injector is very high, it cannot be measured. 1. Measuring pressure in fuel low-pressure circuit 1) Open the engine hood and remove fuel pressure pickup plug (1) from the fuel main filter. k If the engine cannot be started, you may measure the fuel pressure while rotating the engine with the starting motor. Do not rotate for more than 20 seconds continu- ously, however, for protection of the starting motor. 2) Install adapter F2 and nipple [1] of hydrau- lic tester F1 and connect them to oil pres- sure gauge [2] a Use the oil pressure gauge of 2.5 MPa {25 kg/cm 2 }.
4) After finishing measurement, remove the measuring tools and return the removed parts. 3 Fuel pressure pickup plug: 10 ± 2 Nm {1 ± 0.2 kgm} 16 PC210, 230, 240-8 Symbol Part No. Part name F 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 6732-81-3170 Adapter (10 × 1.0 mm o R1/8) 6215-81-9710 O-ring 3 799-401-2320 Hydraulic tester At low idle 0.5 – 1.3 MPa {5.1 – 13.3 kg/cm2} During cranking 0.3 – 1.1 MPa {3.1 – 11.3 kg/cm2}