30 Testing and adjusting UEN00228-00 2. Measuring pressure in fuel return circuit 1) Open the engine hood and remove fuel pressure pickup plug (2) from the fuel return block. 4) After finishing measurement, remove the measuring tools and return the removed parts. 3 Fuel pressure pickup plug: 24 ± 4 Nm {2.4 ± 0.4 kgm} 2) Install nipple [3] of hydraulic tester F1 and nipple [1] and connect them to hydraulic tester F3 . a Nipple [3]: 790-301-1181, 07002-11223 3) Run the engine at low idle and measure the pressure in the fuel return circuit. a If the pressure in the fuel return circuit is in the following range, it is normal.
k If the engine cannot be started, you may measure the fuel pressure while rotating the engine with the starting motor. Do not rotate for more than 20 seconds continu- ously, however, for protection of the starting motor. PC210, 230, 240-8 17 At low idle Max. 0.02 MPa {Max. 0.19 kg/cm2} During cranking