UEN00228-00 30 Testing and adjusting Measuring fuel return rate and leakage 1 a Measuring tools for fuel return rate and leak- age k Stop the machine on a level ground and lower the work equipment to the ground. 5) After finishing measurement, remove the measuring tools and return the removed parts. 1. Measuring return rate from supply pump 1) Open the engine hood and disconnect return hose (1) of the supply pump. 2. Measuring leakage from pressure limiter 1) Open the engine hood and disconnect return hose (2) of the pressure limiter. 2) Connect testing tool G1 to the supply pump side and insert its end in measuring cylinder G4 .
3) Connect blocking tool G1 to the return hose side to prevent the fuel from leaking. 4) Run the engine at low idle and measure the return rate from the supply pump. a If the return rate from the supply pump is in the following range, it is normal. 2) Connect testing tool G2 to the pressure limiter side and insert its end in measuring cylinder G4 . 3) Connect blocking tool G2 to the return hose side to prevent the fuel from leaking. 4) Run the engine at low idle and measure the leakage from the pressure limiter. a If the leakage from the pressure lim- iter is in the following range, it is nor- mal.
k If the engine cannot be started, you may measure the fuel return rate while rotating the engine with the starting motor. Do not rotate for more than 20 seconds continu- ously, however, for protection of the starting motor. At low idle 0 cc (No leakage) 18 PC210, 230, 240-8 Symbol Part No. Part name G 1 (Not set yet) Supply pump testing tool 2 (Not set yet) Pressure limiter testing tool 3 (Not set yet) Injector testing tool 4 Commercially available Measuring cylinder At low idle Max. 1,000 cc/min During cranking Max. 140 cc/min