Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring swing circle bearing clearance

UEN00228-00 30 Testing and adjusting Measuring swing circle bearing clearance 1 4. Set the arm almost perpendicular to the ground and lower the boom until the front track shoe floats. a At this time the front of the upper structure rises and the rear lowers. a Measuring tools for swing circle bearing clear- ance 5. Under this condition, read dial gauge H . a The value indicated by dial gauge H is the clearance of the bearing. a For the standard value, see Structure, function and maintenance standard, “Swing circle”. a When measuring the swing circle bearing clearance installed to the machine, perform the following procedure.

k Stop the machine on a level ground and lower the work equipment to the ground. k Do not put your hands or feet under the undercarriage during measurement. 1. Fix dial gauge H to the track frame and apply the probe to the lower end of the outer race. 6. Return the machine to the condition of step 2 and check that dial gauge H indicates 0. a If the dial gauge does not indicate 0, repeat steps 2 through 5. 2. Set the work equipment to the maximum reach position and set the bucket tip to the height of the under side of the revolving frame. a At this time the front of the upper structure lowers and the rear rises. 3. Set dial gauge H to the 0 point. 24 PC210, 230, 240-8 Symbol Part No.

Part name H Commercially available Dial gauge