Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Special functions of machine monitor

UEN00229-00 30 Testing and adjusting 3. When the ordinary screen is displayed again, large working mode monitor (a) is displayed for 2 seconds, and then the setting of the working mode is changed. a When large monitor (a) is displayed, the display of working mode monitor (b) is changed, too. Selection of travel speed While the ordinary screen is displayed, if the travel speed shifting switch is pressed, large travel speed monitor (a) is displayed for 2 seconds and the set- ting of the travel speed is changed. a Each time the travel speed shifting switch is pressed, the travel speed is changed to Lo, Mi, Hi, and Lo again in order.

a When large monitor (a) is displayed, the dis- play of travel speed monitor (b) is changed, too. q If breaker mode [B] is selected, both of the control of the hydraulic pump and the setting of the hydraulic circuit are changed. q If an attachment other than the breaker is used, the machine may move unexpectedly or may not operate normally or the hydraulic components may be damaged. Operation to stop alarm buzzer While the alarm buzzer is sounding, if the alarm buzzer cancel switch is pressed, the alarm buzzer stops. a Even if the alarm buzzer cancel switch is pressed, the screen does not change.

q After the breaker mode is selected, the screen to confirm the selection of the breaker mode is displayed (The buzzer sounds intermittently while this screen is displayed). q If the setting is confirmed on this screen, the screen changes to the ordinary screen. If No is selected: Working mode is set to economy mode [E] If Yes is selected: Working mode is set to breaker mode [B] 10 PC210, 230, 240-8