UEN00229-00 30 Testing and adjusting Function of changing attachment/maintenance password When changing the attachment/maintenance pass- word used for the attachment setting function and maintenance setting function, follow these proce- dures. 1. While the ordinary screen is displayed, perform the following operation with the numeral input switches. 3. After the New password input screen is dis- played, input a new password with the numeral input switches and confirm it with the function switch. a Set a new password of 4 – 6 digits (If it has only 3 or less digits or has 7 or more digits, it is not accepted). q [F5]:
Reset input numeral/Return to ordi- nary screen q Operation of switches (While pressing [4], perform the operation in order): [4] + [5] o [5] o [5] a This operation of the switches is not accepted until 10 minutes pass after the starting switch is turned on. q [F6]: Confirm input numeral 4. After the New password input screen is dis- played again, input a new password again with the numeral input switches and confirm it with the function switch. q [F5]: Reset input numeral/Return to ordi- nary screen 2. After the Attachment/Maintenance PASS- WORD screen is displayed, input the current password with the numeral input switches and confirm it with the function switch. q [F6]:
Confirm input numeral a If a password different from the password input before is input, the message to input again is displayed. q [F5]: Reset input numeral/Return to ordi- nary screen q [F6]: Confirm input numeral a Default password: [000000] a If the input password is correct, the screen changes to the next screen. a If the input password is incorrect, the mes- sage to input the password again is dis- played. 18 PC210, 230, 240-8