UEN00229-00 30 Testing and adjusting Default (With/Without attachment) Check or change various settings related to the machine monitor and machine by "Default". The "With/Without attachment" function is used to set an installed or a remove attachment. a When an attachment is installed, if this setting is not carried out normally, the attachment cannot be set in the operator mode. As a result, the attachment may not work normally or the hydraulic compo- nents may have trouble. 1. Selecting menu Select "Default" on the service menu screen. 2. Selecting sub menu After the "Default" screen is displayed, select With/Without attachment with the function switches or numeral input switches.
a Select this item similarly to an item on the Service menu screen. 3. Selecting With/Without After the "With/Without attachment" screen is displayed, select the setting with the function switches. q Without: When attachment is not installed q With : When attachment is installed q [F3] : Move to lower item q [F4] : Move to upper item q [F5] : Cancel selection and return to Default screen q [F6] : Confirm selection and return to Default screen 40 PC210, 230, 240-8