UEN00229-00 30 Testing and adjusting Default (Setting of camera) Check or change various settings related to the machine monitor and machine by "Default". The camera setting function is used to set installa- tion and removal of a camera. 3. Selecting camera setting After the camera setting screen is displayed, select the setting with the function switches. q OFF: Camera is not used q Original image: Image of connected cam- era is displayed in origi- nal position (as in mirror, used as back monitor) 1. Selecting menu Select "Default" on the service menu screen.
q Reverse image:Image of connected cam- era is displayed in reverse position (as seen directly, used as front or side mon- itor) q [F3]: Move to left item q [F4]: Move to right item q [F5]: Cancel setting before confirmation and return to "Default" screen q [F6]: Confirm selection in each line a After Camera screen is displayed, camera 1 can be always set. When 2 or more cameras are connected, if camera 1 is set, the screen changes to setting of camera 2 automatically. a After confirming the setting of each line with [F6], return to the "Default" screen with [F5], and the setting is effective.
a If a camera is connected but not set nor- mally with this function, the graphic mark of camera is not displayed at [F3] in the operator mode. Accordingly, the image of the camera cannot be used. a If 2 or more cameras are connected, be sure to set the use of them from camera 1 in order. a The function of displaying 2 images simul- taneously is effective when use of camera 1 and camera 2 is set. a When a camera is installed, check that the displayed image is not inverted horizon- tally. 2. Selecting sub menu After the "Default" screen is displayed, select Camera with the function switches or numeral input switches. a Select this item similarly to an item on the Service menu screen.
42 PC210, 230, 240-8