Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Handling high-voltage circuit of engine controller

UEN00230-00 30 Testing and adjusting Testing and adjusting, Part 3 1 Handling high-voltage circuit of engine controller 1 k The engine controller uses a high-voltage circuit (max. 65 V) to drive the injector. Accordingly, the high-voltage circuit is con- nected to the wiring harnesses and connec- tors between the engine controller and injector. a Normally, the engine controller keeps output- ting the high voltage to the injector only while the engine is running and stops outputting when the engine stops. k If you touch the high-voltage circuit directly, you may get an electric shock. To avoid this, observe the following precau- tions when testing. 1.

The following connectors are used in the high- voltage circuit. q Engine controller connector: CE01 q Injector intermediate connectors: INJ CYL 1 and 2, INJ CYL 3 and 4, INJ CYL 4 and 5 q Injector head terminal (in head cover) 2. When disconnecting or connecting a connector related to the high-voltage circuit, be sure to turn the starting switch OFF. 3. If a T-adapter is inserted in or connected to a connector related to the high-voltage circuit for troubleshooting, do not start the engine. a You may turn the starting switch to the OFF or ON position but must not turn it to the START position. 2 PC210, 230, 240-8