Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Preparation work for troubleshooting of electrical system

30 Testing and adjusting UEN00230-00 Preparation work for troubleshooting of electrical system 1 4) Insert or connect troubleshooting T-adapt- ers in or to connectors CM01 , CM02 , and CM03 of machine monitor (4). a Connectors CM02 and CM03 are of the same type. When returning them, check the mark plates of the mount- ing brackets and take care not to make a wrong connection. a When carrying out troubleshooting of an elec- tric circuit related to the machine monitor, engine controller, pump controller, or KOMTRAX communication MODEM, expose the related connectors according to the follow- ing procedure.

a Disconnect and connect the connectors having special locking mechanisms according to the procedure shown below. 1. Machine monitor 1) Remove mounting bolts (2) and cover (1). a One of the mounting bolts is installed in the cover on the right of the day- light sensor. a While removing the mounting bolts, disconnect connector P31 of the day- light sensor. 2) Remove cover (1). a The cover is fixed with clips. Remove it by pull it up. a While removing the cover, discon- nect connector M04 of the cigarette lighter. 2. Engine controller 1) Open the engine hood. a The engine controller is mounted on the engine (on the counterweight side).

2) Insert or connect troubleshooting T-adapt- ers in or to connectors CE01 , CE02 , and CE03 of engine controller (5). a Connectors CE01 and CE02 are fixed with screws. When disconnecting them, loosen the screws. a When returning connectors CE01 and CE02 , tighten the screws to the spec- ified torque. 3 Screw: 3 ± 1 Nm {0.3 ± 0.1 kgm} 3) Remove 1 mounting bolt and duct (3). PC210, 230, 240-8 3