UEN00241-00 40 Troubleshooting Failure code [CA689] Eng Ne Speed Sensor Error 1 28 PC210, 230, 240-8 User code Failure code Trouble Engine Ne speed sensor error (Engine controller system) E15 CA689 Contents of trouble • There is error in signal from engine Ne speed sensor. Action of controller • Continues control with signal from engine Bkup speed sensor. Problem that appears on machine • Engine hunts. • Engine does not start easily. • Engine output lowers. Related infor- mation • Method of reproducing failure code: Start engine.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective Ne speed sensor power supply system If failure code [CA238] is also displayed, carry out troubleshooting for it first. 2 Defective engine Ne speed sensor a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. CRANK SENSOR Voltage Between (1) – (2) Power supply 4.75 – 5.25 V Voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.
3 Breakage or improper clear- ance of engine Ne speed sensor Engine Ne speed sensor may be broken or may have improper clearance. Check it directly. 4 Breakage of rotation sensor wheel Rotation sensor wheel may be broken. Check it directly. 5 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CE01 (female) (27) – CRANK SENSOR (female) (3) Resis- tance Max.
10 z 6 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CE01 (female) (27) – CRANK SENSOR (female) (3) Resis- tance Min. 100 kz 7 Hot short (Short circuit with 5V/24V circuit) in wiring har- ness a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between CE01 (female) (27) – CRANK SENSOR (female) (3) Voltage Max. 1 V 8 Short circuit in wiring har- ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
Wiring harness between CE01 (female) (27) – CRANK SENSOR (female) (3) or between CE01 (female) (16) – CRANK SENSOR (female) (1) Resis- tance Min. 100 kz Wiring harness between CE01 (female) (27) – CRANK SENSOR (female) (3) or between CE01 (female) (48) – CRANK SENSOR (female) (2) Resis- tance Min. 100 kz