UEN00241-00 40 Troubleshooting Failure code [CA2185] Throt Sens Sup Volt High Error 1 Circuit diagram related to fuel control dial 38 PC210, 230, 240-8 User code Failure code Trouble Throttle sensor supply voltage high error (Engine controller system) E14 CA2185 Contents of trouble • High voltage (5.25 V or higher) was detected in throttle sensor power supply circuit. Action of controller • If trouble occurs while starting switch is in ON position, controller fixes voltage value to level just before detection of trouble and continues operation. • If starting switch is turned ON while voltage is abnormally high, controller continues operation with voltage at 100% value.
Problem that appears on machine • Engine speed cannot be controlled with fuel control dial. Related infor- mation • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Short circuit in wiring har- 1 ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CE02 (female) (22) – each of CE02 (female) pins (With P20 dis- connected) Resis- M tance in. 100 kz Wiring harness between CE02 (female) (22) – CE03 (female) (3) (With P20 disconnected) Resis- M tance in.
100 kz Defective wiring harness 2 connector Connecting parts between fuel control dial – machine wiring har- ness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 3 Defective engine controller If causes 1 – 2 are not detected, engine controller may be defective. (Since trouble is in system, troubleshooting cannot be carried out.)