Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Failure code [DA25KP] 5V Sensor 1 Power Abnormality

40 Troubleshooting UEN00241-00 Failure code [DA25KP] 5V Sensor 1 Power Abnormality 1 Overload alarm monitor non-display specification PC210, 230, 240-8 51 User code Failure code Trouble 5V sensor power supply output 1 abnormality (Pump controller system) — DA25KP Contents of trouble • Voltage of 5V sensor power supply output 1 circuit is below 2.5 V or above 6.0 V. Action of controller • Turns output of 5V sensor power supply output 1 OFF. • Even if cause of failure disappears, system does not reset itself until starting switch is turned OFF. Problem that appears on machine • Automatic gear shifting function does not work (pump pressure sensor system).

• Fine control performance of work equipment lowers (PPC pressure sensor system). Related infor- mation • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective pressure sensor (Internal short circuit) a Disconnect connector with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Disconnect sensors at right in order and carry out operation to reproduce trouble. If "E" of failure code goes off when a sensor is disconnected, that sensor is defective.

Bucket CURL PPC pressure sensor P01 Swing LEFT PPC pressure sensor P03 Arm IN PPC pressure sensor P04 Bucket DUMP PPC pressure sensor P05 Boom RAISE PPC pressure sensor P06 Swing RIGHT PPC pressure sensor P07 F pump pressure sensor P25 R pump pressure sensor P26 2 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between C01 (female) (9) – J06 – P01 (female) (3) [Bucket CURL PPC pressure sensor system] Resis- tance Min. 1 Mz Wiring harness between C01 (female) (9) – J06 – P03 (female) (3) [Swing LEFT PPC pressure sensor system] Resis- tance Min.

1 Mz Wiring harness between C01 (female) (9) – J06 – P04 (female) (3) [Arm IN PPC pressure sensor system] Resis- tance Min. 1 Mz Wiring harness between C01 (female) (9) – P05 (female) (3) [Bucket DUMP PPC pressure sensor sys- tem] Resis- tance Min. 1 Mz Wiring harness between C01 (female) (9) – J06 – P06 (female) (3) [Boom RAISE PPC pressure sensor system] Resis- tance Min. 1 Mz