40 Troubleshooting UEN00245-00 H-1 Speed or power of whole work equipment, swing, and travel is low 1 PC210, 230, 240-8 7 Trouble • Speed or power of whole work equipment, swing, and travel is low. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of unload valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting.
Control levers Unload pressure All levers in neutral 3.5 ± 1.0 MPa {36 ± 10 kg/cm2} 2 Defective adjustment or mal- function of main relief valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Left work equipment control lever Main relief pressure Arm curl relief 33.3 – 36.8 MPa {340 – 375 kg/cm2} If oil pressure does not become normal after adjustment, main relief valve may have malfunction or internal defect. Check main relief valve directly. 3 Malfunction of self-reducing pressure valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting.
Control levers Control circuit basic pressure All levers in neutral 2.84 – 3.43 MPa {29 – 35 kg/cm2} 4 Malfunction of PC-EPC valve a Prepare with engine stopped, then run engine at high idle and low idle and carry out troubleshooting at each speed. Engine Control lever PC-EPC valve output pressure Low idle All levers in neutral 2.9 MPa {30 kg/cm2} High idle 0.52 – 0.91 MPa {5.3 – 9.3 kg/cm2} 5 Defective adjustment or malfunction of PC valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Measured oil pressure Measurement condition Oil pressure ratio Pump discharge pressure Swing lock switch: ON Arm curl relief 1 PC valve output pressure Approx.
0.6 (Approx. 3/5) If oil pressure does not become normal after adjustment, PC valve may have malfunction or internal defect. Check PC valve directly. 6 Malfunction of LS-EPC valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Travel speed Travel lever LS-EPC valve output pressure Lo Neutral Approx. 2.9 MPa {30 kg/cm2} Hi Operated 0 MPa {0 kg/cm2}