40 Troubleshooting UEN00245-00 H-2 Engine speed lowers extremely or engine stalls 1 PC210, 230, 240-8 9 Trouble • Engine speed lowers extremely or engine stalls. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective adjustment or malfunction of main relief valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting.
Left work equipment control lever Main relief pressure Arm curl relief 33.3 – 36.8 MPa {340 – 375 kg/cm2} If oil pressure does not become normal after adjustment, main relief valve may have malfunction or internal defect. Check main relief valve directly. 2 Malfunction of PC-EPC valve a Prepare with engine stopped, then run engine at high idle and low idle and carry out troubleshooting at each speed. Engine Control lever PC-EPC valve output pressure Low idle All levers in neutral 2.9 MPa {30 kg/cm2} High idle 0.52 – 0.91 MPa {5.3 – 9.3 kg/cm2} 3 Defective adjustment or malfunction of PC valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting.
Measured oil pressure Measurement condition Oil pressure ratio Pump discharge pressure Swing lock switch: ON Arm curl relief 1 PC valve output pressure Approx. 0.6 (Approx. 3/5) If oil pressure does not become normal after adjustment, PC valve may have malfunction or internal defect. Check PC valve directly. 4 Defective adjustment or malfunction of LS valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Measured oil pressure Operation of levers and oil pressure ratio All levers in neutral Travel with no load (Lever operated half- way) Pump discharge pressure Almost same pressure 1 PC valve output pressure Approx. 0.6 (Approx.
3/5) If oil pressure does not become normal after adjustment, LS valve may have malfunction or internal defect. Check LS valve directly. 5 Clogging of orifice or filter in serve devices Orifices or filters in pump servo devices may be clogged. Check them directly. 6 Malfunction of servo piston Servo piston may have malfunction. Check it directly.