UEN00245-00 40 Troubleshooting H-14 Power maximizing function does not work 1 H-15 In compound operation of work equipment, speed of part loaded more is low 1 18 PC210, 230, 240-8 Trouble • Power maximizing function does not work. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of 2-stage relief solenoid valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting.
Swing lock switch 2-stage relief solenoid valve output pressure OFF 0 MPa {0 kg/cm2} ON 2.9 MPa {30 kg/cm2} 2 Malfunction of main relief valve Main relief valve may have malfunction. Check it directly. Trouble • In compound operation of work equipment, speed of part loaded more is low. Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of control valve (pressure compensation valve) on less load side Pressure compensation valve of control valve on less load side may have malfunction. Check it directly.
Compound operation Larger load side Less load side Boom raise + Arm curl Boom raise Arm curl Boom raise + Arm dump Arm dump Boom raise Boom raise + Bucket curl Boom raise Bucket curl Arm dump + Bucket curl Arm dump Bucket curl Boom lower + Arm dump Arm dump Boom lower