Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — H-13 When part of work equipment is relieved singly, other parts of work equipment move

40 Troubleshooting UEN00245-00 H-12 Time lag of work equipment is large 1 H-13 When part of work equipment is relieved singly, other parts of work equipment move 1 PC210, 230, 240-8 17 Trouble • Time lag of work equipment is large. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of LS-EPC valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Travel speed Travel lever LS-EPC valve output pressure Lo Neutral Approx. 2.9 MPa {Approx.

30 kg/cm2} Hi Operated 0 MPa {0 kg/cm2} 2 Malfunction of control valve (regeneration valve) [Boom and arm only] Regeneration valve of control valve may have malfunction. Check it directly. 3 Malfunction of control valve (safety-suction valve) Safety-suction valve of control valve may have malfunction. Check it directly. a This safety-suction valve may be checked by replacing it with safety-suction valve of normal control valve and seeing change of condition. (Set pressure of safety-suction valve for boom head circuit is different, however.) 4 Malfunction of control valve (pressure compensation valve) Pressure compensation valve of control valve may have malfunc- tion. Check it directly.

Trouble • When part of work equipment is relieved singly, other parts of work equipment move Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective seal of control valve (pressure compensa- tion valve) on moving side Seal of pressure compensation valve of control valve on moving side may be defective. Check it directly.