Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — H-11 Hydraulic drift of work equipment is large

UEN00245-00 40 Troubleshooting 16 PC210, 230, 240-8 Trouble (3) Hydraulic drift of bucket is large. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective bucket cylinder a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Left work equipment control lever Leakage from bucket cylinder Bucket curl relief 20 cc/min 2 Defective seal of bucket control valve (spool) Seal of bucket control valve spool may be defective. Check it directly.

3 Defective seal of bucket con- trol valve (pressure compen- sation valve) Seal of pressure compensation valve of bucket control valve may be defective. Check it directly. 4 Defective seal of bucket control valve (safety-suction valve) Seal of safety-suction valve of bucket control valve may defective. Check it directly. a Safety-suction valves on bottom side and head side may be checked by replacing them with each other and seeing change of condition.