40 Troubleshooting UEN00245-00 H-11 Hydraulic drift of work equipment is large 1 PC210, 230, 240-8 15 Trouble (1) Hydraulic drift of boom is large. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective boom cylinder a Prepare with engine stopped, then run engine at high idling and carry out troubleshooting. Right work equipment control lever Leakage from boom cylinder Boom raise relief 20 cc/min 2 Defective seal of boom control valve (lock valve) Seal of lock valve of boom control valve may be defective. Check it directly.
3 Defective seal of safety valve for lock valve Seal of safety valve for lock valve may be defective. Check it directly. Trouble (2) Hydraulic drift of arm is large. Related information • Carry out all troubleshooting in power mode (P) of working mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective arm cylinder a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Left work equipment control lever Leakage from arm cylinder Arm curl relief 20 cc/min 2 Defective seal of arm control valve (spool) Seal of arm control valve spool may be defective. Check it directly.
3 Defective seal of arm con- trol valve (pressure compen- sation valve) Seal of pressure compensation valve of arm control valve may be defective. Check it directly. 4 Defective seal of arm control valve (suction valve) Seal of suction valve of arm control valve may be defective. Check it directly. a This suction valve may be checked by replacing it with another suction valve and seeing change of condition. 5 Defective seal of safety valve for lock valve Seal of safety valve for lock valve may be defective. Check it directly.