Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — How to read this manual

UEN00659-00 50 Disassembly and assembly Disassembly and assembly related information 1 How to read this manual 1 1. Removal and installation of assemblies Special tools Removal q Special tools which are deemed neces- sary for removal or installation of parts are described as A1 X1 etc. and their part names, part numbers and quantities are described in the special tool list. q The [Removal] section contains procedures and precautions for implementing the work, know how and the amount of oil or water to be drained. q Various symbols used in the Removal Section are explained and listed below. q Also the following information is described in the special tool list. 1) Necessity t :

Special tools that cannot be substi- tuted and should always be used (installed). q : Special tools that will be useful if avail- able and are substitutable with com- mercially available tools. 2) Distinction of new and existing special tools N : Tools newly developed for this model. They respectively have a new part number. R : Tools with upgraded part numbers. They are remodeled from already available tools for other models. Blank: Tools already available for other models. They can be used without any modification. 3) Circle mark Q in sketch column: k : This mark indicates safety-related precau- tions that must be followed when imple- menting the work. a :

Know-how or precautions for work [*1] : This mark shows that there are instructions or precautions for installing parts. 6 : This mark shows the amount of oil or water to be drained. 4 : Weight of part or component Installation q Except where otherwise instructed, installation of parts is done in the reverse order of removal. q Instructions and precautions for installing parts are shown with mark in the Installation Section, identifying which step the instructions are intended for. q Marks shown in the Installation Section stand for the following. q The sketch of the special tool is pre- sented in the section of "Sketches of special tools". k :

Precautions related to safety in execution of work. 1 : Work that must be carried out with extreme care for safety of machine. a : Know-how or precautions for work q Part No. of special tools starting with 79 T- - : means that they can not be supplied from Komatsu in Japan (i.e. locally made parts). * *** **** 2 : Type of coating material 3 : Tightening torque a General tools that are necessary for removal or installation are described as [1],[2]•••etc. and their part names, part numbers and quantities are not described. 5 : Quantity of oil or coolant to be added Sketches of special tools q Various special tools are illustrated for the con- venience of local manufacture. 2 PC210, 230, 240-8