UEN00660-00 50 Disassembly and assembly 14. Remove bellows (20). [*7] 15. Remove clamp (21) from the cylinder block and disconnect fuel supply tube (22). [*8] a FSP: Fuel supply pump 16. Remove six bellows (23). [*9] a Cylinder head side only 17. Disconnect six high-pressure pipes (24) at the cylinder head side. [*10] 18. Remove common rail and high-pressure pipe assembly (25). [*11] 20. Remove blow-by duct (26). [*12] 21. Remove head cover (27). [*13] 22. By cranking, align mark 1 (M1) at the damper side with mark 2 (M2) at the engine speed sen- sor side. a Be careful that the aligning position is not the 1st and 6th cylinder top position but the 3rd and 4th cylinder top position.
a Mark 1 (M1) corresponds to wide-width slit (WS). a Refer to the Adjusting of Valve Clearance section in the Testing and adjusting chap- ter of this manual. a Use tool A4 (refer to the tool list) for crank- ing. 19. Remove muffler heat insulation cover (40). a Secure space to remove blow-by duct (26). 23. Remove nuts (28) for the harnesses from the injector. [*14] Harness color Cylinder No. White 1, 3, 5 Black 2, 4, 6 24. Remove 12 mounting bolts and remove six rocker arm and crosshead assemblies (31). a Loosen locknut (29) and then loosen adjustment screw (30) a few turns so that excessive force is not put on the push rod when the rocker arm is installed. 6 PC210, 230, 240-8