Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of fuel injector assembly

50 Disassembly and assembly UEN00660-00 [*1] 2. Rocker arm and crosshead assembly 1) Install rocker arm and crosshead assem- bly (31). a When reusing the crosshead, install the same intake and exhaust valves in the same direction because the shapes of its holes a and b are differ- ent, a Tighten the mounting bolt after check- ing that the ball portion of adjustment screw (30) is well seated in the push rod socket. 3 Bracket mounting bolt: 43 ± 6 Nm {4.4 ± 0.6 kgm} [*2] 3 Air intake connector mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} q MIKALOR clamp a Use a new clamp. a Align the hose to the original position (marking position). a Reference Depth of insertion:

60mm (aftercooler side) a Set bridge (BR) under the clamp tightening bolt as the lap with band (BR) is Min.5mm. a Align the clamp to the original position. a Impact wrench is not applicable to use. 3 Mounting bolt: 36 ± 5 Nm {3.7 ± 0.5 kgm} 2) Adjust the valve clearances. a Refer to the Adjusting of Valve Clear- ance section in the Testing and adjusting chapter of this manual. 3 Locknut (29): 24 ± 4 Nm {2.4 ± 0.4 kgm} 3 Clamp: 16 – 18 Nm {1.6 – 1.8 kgm} a When the tightening torque force is less than 16Nm{1.6kgm}, tighten it until the hand gap is adhered (BDG size is 0). [*3] 3 Joint bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} [*4] 3 Mounting bolt:

24 ± 4 Nm {2.4 ± 0.4 kgm} [*5] 3 Fuel block mounting bolt: 32 ± 4 Nm {3.3 ± 0.4 kgm} [*6] k When installing, keep the distance of more than 10 mm between the high-pressure pipe and the harness. q Carry out the rest of installation in the reverse order to removal. PC210, 230, 240-8 9