Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of fuel injector assembly

UEN00660-00 50 Disassembly and assembly [*7], [*8], [*9], [*10], [*11] a Coat the two bolt threads on the inner side of the engine with sealant (LG-7). q High-pressure pipes and common rail k Do not use high-pressure pipes with bend- ing modification. 3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} 9) Install bellows (23) to each high-pressure pipe. (14 pieces) a Set the slits of each bellows out and down. a The bellows are installed so that fuel will not spout over the hot parts of the engine and catch fire when it leaks for some reason. a FSP: Fuel supply pump k Be sure to use a genuine high-pressure pipe fixing clamp and observe strictly the tightening torque.

a A high-pressure pipe which has depressions such as visible vertical slit scar (b), patchy scars (c) etc. on the taper seal section of its connector ((a) part: within 2mm from the tip), or a high- pressure pipe whose (d) part (end of the taper seal section: 2mm from the tip) catches on a fin- ger nail due to fatigue, may cause fuel leakage. In these cases, replace the high-pressure pipe. 3) Assemble common rail (25) and high- pressure pipes (51) -(56) temporarily. 3 Sleeve nut and mounting bolt: 0.2 – 0.8 Nm {0.02 – 0.08 kgm} 4) Tighten high-pressure pipes (51) - (56) according to the following procedure. 3 Sleeve nut:

35 ± 3.5 Nm {3.6 ± 0.4 kgm} 1] Head side of high-pressure pipes (51) and (56) 2] Common rail (25) side of high-pres- sure pipes (51) and (56) 3] Head side of high-pressure pipes (52), (53), (54) and (55) 4] Common rail (25) side of high-pres- sure pipes (52), (53), (54) and (55) 5) Tighten the sleeve nut of high-pressure pipe (22) temporarily. 6) Tighten high-pressure pipe (22) in the order of firstly pump (FSP) side, then com- mon rail (25) side. [*12] 3 Blow-by duct mounting bolt: 10 ± 2 Nm {1.0 ± 0.2 kgm} [*13] 3 Head cover mounting nut: 24 ± 4 Nm {2.4 ± 0.4 kgm} 3 Sleeve nut: 35 ± 3.5 Nm {3.6 ± 0.4 kgm} 7) Tighten clamp (21) of high-pressure pipe (22).

[*14] a Harness installation position 3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} 8) Tighten common rail (25) with four bolts. 3 Harness mounting nut: 1.5 ± 0.25 Nm {0.15 ± 0.03 kgm} 10 PC210, 230, 240-8 Harness color Cylinder No. White 1, 3, 5 Black 2, 4, 6